New Features
Replies: 4
by
gregmcc »
Thu Apr 23, 2020 11:50 am
» in
Announcements
Hi everybody,
Just thought it was time for an update. We have over 160 members which is very good. Thank you for your support!
A few new features...
4 Replies
184232 Views
Last post by gregmcc
Thu Apr 23, 2020 12:23 pm
1 Replies
1884 Views
Last post by AlecK
Tue Sep 10, 2024 1:47 pm
Inverter in connectable installation
Replies: 16
by
JamieP »
Tue Jan 03, 2023 1:38 pm
Rating: 11.11%
Am I right in saying that an inverter must comply with AS/NZS 4763 to be used in a connectable installation?
I've had some debate around 3.4.4.4...
16 Replies
40992 Views
Last post by AlecK
Fri Jun 28, 2024 11:50 am
CI switchboard in damp situation
Replies: 4
by
Dan L »
Thu May 04, 2023 10:18 pm
For a switchboard in zone 2 of damp area. Fixed water container (sink) (assuming in cupboard under sink is still in zone)
Switchboard not permitted...
4 Replies
15970 Views
Last post by Dan L
Wed Jul 26, 2023 9:28 am
Do leads need to be HD flexible cord?
Replies: 1
by
JamieP »
Wed May 31, 2023 3:00 pm
I saw in the WoEF checks in the new version it says it must be HD flex
Is this a mistake? Wouldn't this make any existing lead that is OD cord or...
1 Replies
8828 Views
Last post by AlecK
Thu Jun 01, 2023 11:54 am
Installation batteries
Replies: 3
by
Dan L »
Wed May 03, 2023 10:09 pm
I see nothing for EWOF check for current, 2022 standards or part 1 regarding a battery enclosure or loctation. For new install 2022 there's is...
3 Replies
12876 Views
Last post by AlecK
Fri May 12, 2023 8:50 am
Imported switchgear IEC standards
Replies: 2
by
Dan L »
Wed May 03, 2023 10:14 pm
Technically is IEC Switchgear acceptable to use in NZ. For a standard installation and for CI
Photo attached.
Rcd 30ma Type A
2 Replies
10577 Views
Last post by AlecK
Thu May 04, 2023 10:53 am
Ewof segregation
Replies: 4
by
Dan L »
Wed Apr 19, 2023 11:46 pm
connectable installations shall pass a 500 V d.c. insulation resistance test between the active and each
unearthed extra-low voltage circuit. The...
4 Replies
14107 Views
Last post by AlecK
Fri Apr 21, 2023 9:48 am
3001: 2022 edition
Replies: 4
by
AlecK »
Thu Dec 01, 2022 4:31 pm
Rating: 22.22%
new 2022 edition of 3001 was published mid Nov.
So far only Part 1 is showing on SNZ website via EWRB link, but both parts are there of you go...
4 Replies
17341 Views
Last post by AlecK
Fri Apr 21, 2023 9:13 am
11 Replies
26516 Views
Last post by PeteRig
Wed Apr 19, 2023 2:56 pm
Tiny Home WoEF renewal
Replies: 8
by
Slovett »
Tue Nov 29, 2022 11:34 am
Rating: 22.22%
Apologies if this question has already been answered on another thread -
This question relates to Tiny Home Connectable Installations.
Does a Tiny...
8 Replies
23105 Views
Last post by AlecK
Fri Dec 02, 2022 4:01 pm
Tiny home 32A app inlet and supply
Replies: 2
by
Energy »
Tue Oct 25, 2022 8:55 am
ASNZS 3001 5.1.2 only details 15A, 16A and 20A for supply lead.
Tiny homes or other transportable structures being 32a app inlet and supply lead is...
2 Replies
12286 Views
Last post by AlecK
Tue Oct 25, 2022 12:31 pm
1 Replies
10597 Views
Last post by AlecK
Mon Sep 12, 2022 10:48 am
Volt drop in connectable installations?
Replies: 3
by
JamieP »
Sat Aug 27, 2022 10:48 am
Rating: 11.11%
Are there any specific volt drop limits for connectable installations? Or is it counted in the total limits prescribed in 3000? Do we need to make...
3 Replies
13703 Views
Last post by AlecK
Mon Aug 29, 2022 7:36 pm
Dual Supply Change-over
Replies: 6
by
TPower »
Sun Aug 14, 2022 12:58 pm
Rating: 44.44%
I have a Woef job for a campervan I looked at last week, I’ve failed it at this stage as I don’t think it complies. It was wired a few years ago and...
6 Replies
20930 Views
Last post by AlecK
Thu Aug 18, 2022 6:21 pm
Charger inhibit when running on inverter
Replies: 4
by
1Sparky »
Sat Jun 04, 2022 10:27 am
Rating: 22.22%
Bus converted to a motorhome, 230v side of things - I am fitting a selector switch so the user can select between inverter-off-mains for supply to...
4 Replies
15165 Views
Last post by 1Sparky
Wed Jun 29, 2022 5:04 pm
Evading EWOFs
Replies: 3
by
JamieP »
Wed May 04, 2022 5:34 pm
Rating: 11.11%
I have been supplied a bunch of buildings that are essentially transportable installation. However the buildings have shown up with a mains entry...
3 Replies
13721 Views
Last post by AlecK
Fri May 06, 2022 9:27 am
RCD requirements
Replies: 10
by
DougP »
Fri Feb 18, 2022 9:43 am
Rating: 11.11%
For a tiny home that's plugged in (16 or 32A supply), does the minimum of two RCD requirement apply in a transportable if there is more than one...
10 Replies
28834 Views
Last post by AlecK
Fri Mar 25, 2022 2:42 pm
Imported US boat
Replies: 5
by
PeteRig »
Tue Mar 15, 2022 1:16 pm
Rating: 11.11%
Have a boat that has been imported from the States, and has since had some NZ outlets installed in the boat in NZ, wired separate to the 110V...
5 Replies
17560 Views
Last post by PawPatrol
Fri Mar 25, 2022 12:18 pm
Imported Coffee Cart WoEF
Replies: 9
by
Slovett »
Wed Feb 16, 2022 12:07 pm
I have a job coming up where an Imported Coffee Cart (Transportable Installation) is needing a WoEF.
Because it's imported I'll need to Check Over...
9 Replies
26411 Views
Last post by AlecK
Fri Feb 18, 2022 1:58 pm
Earthing equipment/appliances in caravans
Replies: 6
by
TPower »
Sat Feb 12, 2022 9:58 am
Rating: 33.33%
Just reading through a recent disciplinary hearing, where an inspector got pulled up for failing to test/identify there was no earth connection to...
6 Replies
19696 Views
Last post by TPower
Tue Feb 15, 2022 8:19 pm
Connectable installations - only 90v-250v?
Replies: 7
by
JamieP »
Fri Jan 28, 2022 11:26 am
Just looking at the definitions in the Act and Regs
The scope of 3001 includes up to 1000v but does this mean in the eyes of NZ legislation that any...
7 Replies
20680 Views
Last post by JamieP
Sun Jan 30, 2022 1:29 pm
2 Replies
12155 Views
Last post by JamieP
Thu Jan 06, 2022 11:52 am
10 Replies
26584 Views
Last post by AlecK
Fri Nov 12, 2021 8:26 pm
Transportable Structure Appliance Inlet
Replies: 8
by
PeteRig »
Wed Nov 10, 2021 7:50 am
Rating: 11.11%
Does an appliance inlet require a cover, so that when the connector is not install the pins of the inlet are protected from the elements.
The reason...
8 Replies
22992 Views
Last post by PeteRig
Thu Nov 11, 2021 10:16 am
1 Replies
10184 Views
Last post by AlecK
Wed Nov 10, 2021 11:17 am
Forum permissions
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum